Work On The Left Section Of The Engine Case - KTM 1190 RC8 R EU/UK 2009 Repair Manual
Hide thumbs
Also See for 1190 RC8 R EU/UK 2009:
- Owner's manual (283 pages) ,
- Owner's manual (281 pages) ,
- Owner's manual (242 pages)
Table of Contents
Advertisement
30/ENGINE - WORK ON INDIVIDUAL PARTS
Work on the left section of the engine case
20.5
–
Position bearing shell bracket
Guideline
Screw, bearing retainer
200435-11
–
Remove studs
200448-10
–
Remove screw
–
Remove oil jets
200449-10
–
Remove shaft seal rings
–
Remove any sealing mass remnants and clean the engine case section thoroughly.
–
Warm the engine case section in an oven.
Guideline
150 °C (302 °F)
–
Knock the engine case section against a level wooden plate. This will cause the
bearings to drop out of the bearing seats.
Info
200450-10
Any bearings that remain in the engine case section must be removed using
a suitable tool.
–
Warm the engine case section again.
Guideline
150 °C (302 °F)
–
Insert the new cold bearings into the bearing seats of the hot engine case section
and, if necessary, use a suitable press drift to push the bearing from the inside to
the outside, all the way to the stop or so it is flush.
. Mount and tighten the screws.
M5
.
.
.
.
6 Nm
Loctite
®
243™
(4.4 lbf ft)
141
Advertisement
Table of Contents
