04/SHOCK ABSORBER, SWINGARM
Assembling the piston rod
8.13
–
Check the heim joint for damage and wear.
»
If there is damage or wear:
–
Change the heim joint.
300460-01
–
Clamp the piston rod into a vise with the heim joint.
–
Mount rubber buffer plug
200574-11
–
Position special tool
Mounting sleeve (T313) (
–
Grease the seal ring and slide seal ring retainer
Lubricant (T625) (
–
Remove the special tool.
200575-10
–
Mount supporting plate
–
Mount compression shim stack
200572-11
–
Grind the piston on both sides on a surface plate with 1200 grade sand paper.
–
Clean the piston.
–
Mount the piston.
Info
The piston is identical on both sides.
200576-10
and locking cap
.
on the piston rod.
p. 450)
p. 439)
with the rounded side facing downward.
with the smaller shims at the bottom.
onto the piston rod.
52