AudioCodes Mediant 800B User Manual page 72

Parameter
Password
password
Status
status
Password Age
password-age
Session Limit
session-limit
User's Manual
Defines the Web user's password.
The valid value is a string of 8 to 40 ASCII characters, which must
adhere to the following guidelines:

Include at least eight characters.

Include at least two letters that are upper case (e.g., A).

Include at least two letters that are lower case (e.g., a).

Include at least two numbers (e.g., 4).

Include at least two symbols (non-alphanumeric characters) (e.g., $,
#, %).

Must contain no spaces.

Include at least four new characters that were not used in the
previous password.
Defines the status of the Web user.

New = (Default) User is required to change its password on the next
login. When the user logs in to the Web interface, the user is
immediately prompted to change the current password.

Valid = User can log in to the Web interface as normal.

Failed Login = This state is automatically set for users that exceed a
user-defined number of failed login attempts, set by the 'Deny
Access on Fail Count' parameter (see ''Configuring Web Session
and Access Settings'' on page 75). These users can log in only after
a user-defined timeout configured by the 'Block Duration' parameter
(see below) or if their status is changed (to New or Valid) by a
System Administrator or Master.

Inactivity = This state is automatically set for users that have not
accessed the Web interface for a user-defined number of days, set
by the 'User Inactivity Timer' (see ''Configuring Web Session and
Access Settings'' on page 75). These users can only log in to the
Web interface if their status is changed (to New or Valid) by a
System Administrator or Master.
Notes:

The Inactivity status is applicable only to Admin and Monitor users;
System Administrator and Master users can be inactive indefinitely.

For security, it is recommended to set the status of a newly added
user to New in order to enforce password change.
Defines the duration (in days) of the validity of the password. When this
duration elapses, the user is prompted to change the password;
otherwise, access to the Web interface is blocked.
The valid value is 0 to 10000, where 0 means that the password is
always valid. The default is 90.
Defines the maximum number of concurrent Web interface sessions
allowed for the specific user. For example, if configured to 2, the same
user account can be logged into the device's Web interface (i.e., same
username-password combination) from two different management
stations (i.e., IP addresses) at any one time. Once the user logs in, the
session is active until the user logs off (by clicking the Log off icon on
the toolbar) or until the session expires if the user is inactive for a user-
defined duration (see the 'Session Timeout' parameter below).
The valid value is 0 to 5. The default is 2.
Note: Up to 5 users can be concurrently logged in to the Web interface.
72
Mediant 800B Gateway and E- SBC
Description
Document #: LTRT-10296