Nat And Stun Parameters - AudioCodes Mediant 800B User Manual

Parameter
Layer-3 Class of Service (TOS/DiffServ) Parameters
Media Premium QoS
media-qos
[PremiumServiceClassMediaDiffServ]
Control Premium QoS
control-qos
[PremiumServiceClassControlDiffServ]
Gold QoS
gold-qos
[GoldServiceClassDiffServ]
Bronze QoS
bronze-qos
[BronzeServiceClassDiffServ]

61.2.6 NAT and STUN Parameters

The Network Address Translation (NAT) parameters are described in the table below.
Parameter
NAT Parameters
NAT Mode
disable-NAT-traversal
[NATMode]
User's Manual
[ \DiffServToVlanPriority ]
For example:
DiffServToVlanPriority 0 = 46, 6;
DiffServToVlanPriority 1 = 40, 6;
DiffServToVlanPriority 2 = 26, 4;
DiffServToVlanPriority 3 = 10, 2;
For a description of the table, see Configuring Quality of
Service on page 146.
Note: For the parameter to take effect, a device reset is
required.
Global parameter that defines the DiffServ value for
Premium Media CoS content. You can also configure this
functionality per specific calls, using IP Profiles
(IpProfile_IPDiffServ). For a detailed description of the
parameter and for configuring this functionality in the IP
Profile table, see ''Configuring IP Profiles'' on page 396.
Note: If this functionality is configured for a specific IP
Profile, the settings of this global parameter is ignored for
calls associated with the IP Profile.
Global parameter that defines the DiffServ value for
Premium Control CoS content (Call Control applications).
You can also configure this functionality per specific calls,
using IP Profiles (IpProfile_SigIPDiffServ). For a detailed
description of the parameter and for configuring this
functionality in the IP Profile table, see ''Configuring IP
Profiles'' on page 396.
Note: If this functionality is configured for a specific IP
Profile, the settings of this global parameter is ignored for
calls associated with the IP Profile.
Defines the DiffServ value for the Gold CoS content
(Streaming applications).
The valid range is 0 to 63. The default is 26.
Defines the DiffServ value for the Bronze CoS content
(OAMP applications).
The valid range is 0 to 63. The default is 10.
Table 61-14: NAT Parameters
Enables the NAT feature for media when the device communicates
with UAs located behind NAT.

[0] Auto-Detect = NAT is performed only if necessary. If the UA is
926
Mediant 800B Gateway and E- SBC
Description
Description
Document #: LTRT-10296