AudioCodes Mediant 800B User Manual page 164


To configure a Firewall rule:
1. Open the Firewall Settings page (Configuration tab > VoIP menu > Security >
Firewall Settings).
2. Click Add; the following dialog box appears:
Figure 13-1: Firewall Settings Table - Add Row Dialog Box
3. Configure a Firewall rule according to the parameters described in the table below.
4. Click Add, and then reset the device with a burn-to-flash for your settings to take
effect.
Table 13-1: Firewall Settings Table Parameter Descriptions
Parameter
Index
Source IP
source-ip
[AccessList_Source_IP]
Source Port
src-port
[AccessList_Source_Port]
User's Manual
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines the IP address (or DNS name) or a specific host name
of the source network (i.e., from where the incoming packet is
received).
The default is 0.0.0.0.
Defines the source UDP/TCP ports (of the remote host) from
where packets are sent to the device.
The valid range is 0 to 65535. The default is 0.
Note: When set to 0, this field is ignored and any source port
matches the rule.
164
Mediant 800B Gateway and E- SBC
Description
Document #: LTRT-10296