AudioCodes Mediant 800B User Manual page 890

Parameter
Bandwidth Profile
bandwidth-profile
[Test_Call_BWProfile]
Authentication Tab
Note: These parameters are applicable only if the Call Party parameter is set to Caller.
Auto Register
auto-register
[Test_Call_AutoRegister]
Username
user-name
[Test_Call_UserName]
Password
password
[Test_Call_Password]
Test Setting Tab
Call Party
call-party
[Test_Call_CallParty]
Maximum Channels for
Session
max-channels
[Test_Call_MaxChannels]
Call Duration
call-duration
[Test_Call_CallDuration]
Calls per Second
calls-per-second
[Test_Call_CallsPerSecond]
Test Mode
test-mode
[Test_Call_TestMode]
User's Manual
Assigns a Bandwidth Profile to the test call.
By default, no value is defined (None).
To configure Bandwidth Profiles, see ''Configuring Bandwidth
Profiles'' on page 317.
Enables automatic registration of the endpoint. The endpoint can
register to the device itself or to the 'Destination Address' or 'IP
Group' parameter settings (see above).

[0] Disable (default)

[1] Enable
Defines the authentication username.
By default, no username is defined.
Defines the authentication password.
By default, no password is defined.
Defines whether the test endpoint is the initiator or receiving side of
the test call.

[0] Caller (default)

[1] Called
Defines the maximum number of concurrent channels for the test
session. For example, if you have configured an endpoint "101" and
you set the parameter to "3", the device automatically creates three
simulated endpoints - "101", "102" and "103" (i.e., consecutive
endpoint URIs are assigned).
The default is 1.
Defines the call duration (in seconds).
The valid value is -1 to 100000. The default is 20. A value of 0
means infinite. A value of -1 means that the parameter value is
automatically calculated according to the values of the 'Calls per
Second' and 'Maximum Channels for Session' parameters.
Note: The parameter is applicable only if 'Call Party' is set to Caller.
Defines the number of calls per second.
Note: The parameter is applicable only if 'Call Party' is set to Caller.
Defines the test session mode.

[0] Once = (Default) The test runs until the lowest value between
the following is reached:

Maximum channels is reached for the test session,
configured by 'Maximum Channels for Session'.

Call duration ('Call Duration') multiplied by calls per second
('Calls per Second').

Test duration expires, configured by 'Test Duration'.

[1] Continuous = The test runs until the configured test duration
890
Mediant 800B Gateway and E- SBC
Description
Document #: LTRT-10296