AudioCodes Mediant 800B User Manual page 575

User's Manual
The figure above shows a configuration example where hotline-automatic dialing is
enabled for an FXS port, whereby if the port is off-hooked for over 15 seconds, the
device automatically dials 911.
3. Configure automatic dialing per port according to the parameters described in the
table below.
4. Click Add.
Table 27-2: Automatic Dialing Table Parameter Descriptions
Parameter
Index
[TargetOfChannel_Index]
Module
[TargetOfChannel_Module]
Port
port
[TargetOfChannel_Port]
Port Type
[TargetOfChannel_PortType]
Destination Phone Number
dst-number
[TargetOfChannel_Destination]
Auto Dial Status
auto-dial-status
[TargetOfChannel_Type]
Version 7.0
(Read-only) Displays the index number of the table row.
(Read-only) Displays the module number on which the
port is located.
(Read-only) Displays the port number.
(Read-only) Displays the port type (FXS or FXO).
Defines the destination telephone number to automatically
dial.
Enables automatic dialing.

[0] Disable = Automatic dialing for the specific port is
disabled.

[1] Enable = (Default) Automatic dialing is enabled and
the phone number configured in the 'Destination Phone
Number' field is automatically dialed if the following
occurs:

FXS interfaces: The phone is off-hooked

FXO interfaces: A ring signal (from a PBX/PSTN
switch) is detected on the FXO line. The device
initiates a call to the destination without seizing the
FXO line. The line is seized only after the SIP call
is answered.

[2] Hotline = Automatic dialing is done after an interval
configured by the 'Hotline Dial Tone Duration'
parameter:

FXS interfaces: When the phone is off-hooked and
no digit is dialed within a user-defined time, the
configured destination number is automatically
dialed.

FXO interfaces: If a ring signal is detected, the
device seizes the FXO line, plays a dial tone, and
then waits for DTMF digits. If no digits are detected
within a user-defined time, the configured
destination number is automatically dialed by
sending a SIP INVITE message with this number.
575
27. Analog Gateway
Description
Mediant 800B Gateway and E- SBC