Network; Configuring Physical Ethernet Ports - AudioCodes Mediant 800B User Manual

User's Manual
12

Network

This section describes the network-related configuration.
12.1

Configuring Physical Ethernet Ports

The Physical Ports Settings table lets you configure the device's Ethernet ports. This
includes port speed and duplex mode (half or full), and a brief description of the port.
The table also displays the status of the port (e.g., active) as well as the port group
(Ethernet Group) to which the port belongs. You can assign up to two ports to an Ethernet
Group. Ethernet Groups with two ports are used for 1+1 Ethernet port redundancy. For
more information on Ethernet Groups and for assigning ports to Ethernet Groups, see
''Configuring Ethernet Port Groups'' on page 129.
The device's management tools (e.g., Web interface) use hard-coded strings to represent
the physical ports, as shown below:
To view the mapping of the physical ports to these logical ports (strings) as well as view
port status, use the CLI command, show voip ports. This displays the MAC address and
port status (up or down) of the physical port and its corresponding logical port. Below
shows an example of the mapping results from running this command:
# show voip ports
Port Num
Link Status Native VLAN
----------
--------
1
FULL
2
FULL
Note:
device itself.
The following procedure describes how to configure the Ethernet ports through the Web
interface. You can also configure it through ini file (PhysicalPortsTable) or CLI (configure
voip > physical-port).

To configure the physical Ethernet ports:
1. Open the Physical Ports Settings page (Configuration tab > VoIP menu > Network >
Physical Ports Table).
Version 7.0
Port Name
-----------
-----------
GE4_1
UP
GE4_2
DOWN
All the LAN ports have the same MAC address. This is the MAC address of the
MAC Address
-----------------
------------
00:1e:67:11:7c:28
1
00:1e:67:11:7c:28
127 Mediant 800B Gateway and E- SBC
12. Network
Speed Duplexity
-----------------
100Mbps
100Mbps