Configuring Caller Display Information - AudioCodes Mediant 800B User Manual

User's Manual
27.6

Configuring Caller Display Information

The Caller Display Information table lets you configure caller identification strings (Caller
ID) per FXS and FXO port. this table also lets you enable the device to send the Caller ID
to the IP when a call is made. The called party can use this information for caller
identification. The device sends the configured caller ID in the outgoing INVITE message's
From header. For information on Caller ID restriction according to destination/source
prefixes, see ''Configuring Source/Destination Number Manipulation'' on page 469.
Notes:
•
If an FXS port receives 'private' or 'anonymous' strings in the SIP From header,
the calling name or number is not sent to the Caller ID display.
•
If the device detects Caller ID on an FXO line (EnableCallerID = 1), it uses this
Caller ID instead of the Caller ID configured in the Caller Display Information table.
The following procedure describes how to configure caller ID through the Web interface.
You can also configure it through ini file (CallerDisplayInfo) or CLI (configure voip > gw
analoggw caller-display-info).

To configure Caller display:
1. Open the Caller Display Information table (Configuration tab > VoIP menu >
Gateway > Analog Gateway > Caller Display Information).
2. Click Add; the following dialog box appears:
3. Configure caller display per port according to the parameters described in the table
below.
4. Click Add.
Table 27-3: Caller Display Information Table Parameter Descriptions
Parameter
Index
[CallerDisplayInfo_Index]
Module
[CallerDisplayInfo_Module]
Port
Version 7.0
(Read-only) Displays the index number of the table row.
(Read-only) Displays the module number on which the port is
located.
(Read-only) Displays the port number.
577
27. Analog Gateway
Description
Mediant 800B Gateway and E- SBC