Configuring Snmp V3 Users - AudioCodes Mediant 800B User Manual

8.5

Configuring SNMP V3 Users

The SNMPv3 Users table lets you configure up to 10 SNMP v3 users for authentication
and privacy.
The following procedure describes how to configure SNMP v3 users through the Web
interface. You can also configure it through ini file (SNMPUsers) or CLI (configure system >
snmp v3-users).

To configure an SNMP v3 user:
1. Open the SNMPv3 Users table (Configuration tab > System menu > Management >
SNMP > SNMP V3 Users).
2. Click Add; the following dialog box appears:
Figure 8-4: SNMPv3 Users Table - Add Row Dialog Box
3. Configure the SNMP V3 parameters according to the table below.
4. Click Add, and then save ("burn") your settings to flash memory.
Note: If you delete a user that is associated with a trap destination (see ''Configuring
SNMP Trap Destinations'' on page 92), the configured trap destination becomes
disabled and the trap user reverts to default (i.e., SNMPv2).
Table 8-3: SNMPv3 Users Table Parameters Description
Parameter
Index
[SNMPUsers_Index]
User Name
username
[SNMPUsers_Username]
Authentication Protocol
auth-protocol
[SNMPUsers_AuthProtocol]
Privacy Protocol
User's Manual
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Name of the SNMP v3 user. This name must be unique.
Authentication protocol of the SNMP v3 user.

[0] None (default)

[1] MD5

[2] SHA-1
Privacy protocol of the SNMP v3 user.
94
Mediant 800B Gateway and E- SBC
Description
Document #: LTRT-10296