AudioCodes Mediant 800B User Manual page 465

User's Manual
Parameter
Gateway Name
gateway-name
[TrunkGroupSettings_Gateway
Name]
Contact User
contact-user
[TrunkGroupSettings_ContactU
ser]
Version 7.0
Group table (see ''Configuring IP Groups'' on page 349).
Notes:

If the parameter is not configured, the registration is performed
according to the global registration parameter,
ChannelSelectMode.

To enable Trunk Group registration, set the global parameter,
IsRegisterNeeded to 1. This is unnecessary for 'Per Account'
registration mode.

If the device is configured globally to register Per Endpoint and
an channel group includes four channels to register Per
Gateway, the device registers all channels except the first four
channels. The group of these four channels sends a single
registration request.
Defines the host name for the SIP From header in INVITE
messages, and the From and To headers in REGISTER requests.
Note: If the parameter is not configured, the global parameter,
SIPGatewayName is used.
Defines the user part for the SIP Contact URI in INVITE messages,
and the From, To, and Contact headers in REGISTER requests.
Notes:

The parameter is applicable only if the 'Registration Mode'
parameter is set to 'Per Account' and registration through the
Account table is successful.

If registration fails, the user part in the INVITE Contact header is
set to the source party number.

The 'Contact User' parameter in the Account table overrides this
parameter (see ''Configuring Registration Accounts'' on page
371).
465
Description
Mediant 800B Gateway and E- SBC
22. Trunk Groups