AudioCodes Mediant 800B User Manual page 128

2. Select a port that you want to configure by clicking its table row, and then clicking
Edit; the following dialog box appears:
Figure 12-1: Physical Ports Settings Table - Edit Row Dialog Box
3. Configure the port according to the parameters described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 12-1: Physical Port Settings Table Parameter Descriptions
Parameter
Port
port
[PhysicalPortsTable_Port]
Mode
mode
[PhysicalPortsTable_Mode]
Speed & Duplex
speed-duplex
[PhysicalPortsTable_SpeedDuplex]
Description
port-description
[PhysicalPortsTable_PortDescription]
Group Member
group-member
[PhysicalPortsTable_GroupMember]
User's Manual
(Read-only) Displays the Ethernet port number. The figure in
the beginning of this section shows the mapping of this GUI
port number to the physical port on the chassis.
(Read-only) Displays the mode of the port:

[0] Disable

[1] Enable (default)
Defines the speed and duplex mode of the port.

[0] 10BaseT Half Duplex

[1] 10BaseT Full Duplex

[2] 100BaseT Half Duplex

[3] 100BaseT Full Duplex

[4] Auto Negotiation (default)

[6] 1000BaseT Half Duplex

[7] 1000BaseT Full Duplex
Defines an arbitrary description of the port.
By default, the value is "User Port #<row index>".
(Read-only) Displays the Ethernet Group to which the port
belongs.
To assign the port to a different Ethernet Group, see
''Configuring Ethernet Port Groups'' on page 129.
128
Mediant 800B Gateway and E- SBC
Description
Document #: LTRT-10296