Test Call Configuration Examples - AudioCodes Mediant 800B User Manual

Media gateway & enterprise session border controller (e-sbc)

Hide thumbs Also See for Mediant 800B:

Table of Contents

User's Manual

Test Call Configuration Examples

Below are a few examples of test call configurations.

Single Test Call Scenario: This example describes the configuration of a simple test

call scenario that includes a single test call between a simulated test endpoint on the

device and a remote endpoint.

Test Call table configuration:

Alternatively, if you want to route the test call using the Tel-to-IP Routing table for the

Gateway application, configure the following:

Test Call table configuration:

Tel-to-IP Routing table configuration:

Figure 58-8: Single Test Call Example

Endpoint URI: "101"

Called URI: "201"

Route By: Dest Address

Destination Address: "10.30.40.01"

SIP Interface: SIPInterface_0

Call Party: Caller

Test Mode: Once

Endpoint URI: 101@10.0.0.1

Route By: GW Tel2IP

SIP Interface: SIPInterface_0

Called URI: 201@10.30.40.1

Call Party: Caller

Destination Phone Prefix: 201 (i.e., the Called URI user-part)

Source Phone Prefix: 101 (i.e., the Endpoint URI user-part)

Destination IP Address: 10.30.40.1

Mediant 800B Gateway and E- SBC

58. Testing SIP Signaling Calls