AudioCodes Mediant 800B User Manual page 359

User's Manual
Parameter
Source URI Input
src-uri-input
[IPGroup_SourceUriInput]
Destination URI Input
dst-uri-input
[IPGroup_DestUriInput]
Version 7.0
password is defined.
Notes:

The parameter is applicable only to Server-type IP Groups and
when the 'Authentication Mode' parameter is set to SBC as
Server (i.e., authentication of servers).

To specify the SIP request types (e.g., INVITE) that must be
challenged by the device, use the 'Authentication Method List'
parameter.
Defines the SIP header in the incoming INVITE that is used for call
matching characteristics based on source URIs.

[-1] Not Configured (default)

[0] From

[1] To

[2] Request-URI

[3] P-Asserted - First Header

[4] P-Asserted - Second Header

[5] P-Preferred

[6] Route

[7] Diversion

[8] P-Associated-URI

[9] P-Called-Party-ID

[10] Contact

[11] Referred-by
Notes:

The parameter is applicable only when classification is done
according to the Classification table.

If the configured SIP header does not exist in the incoming
INVITE message, the classification of the message to a source IP
Group fails.

If the device receives an INVITE as a result of a REFER request
or a 3xx response, then the incoming INVITE is routed according
to the Request-URI. The device identifies such INVITEs
according to a specific prefix in the Request-URI header,
configured by the SBCXferPrefix parameter. Therefore, in this
scenario, the device ignores the parameter setting.
Defines the SIP header in the incoming INVITE to use as a call
matching characteristic based on destination URIs. The parameter is
used for classification and routing purposes. The device first uses
the parameter's settings as a matching characteristic (input) to
classify the incoming INVITE to an IP Group (source IP Group) in the
Classification table. Once classified, the device uses the parameter
for routing the call. For example, if set to To, the URI in the To
header of the incoming INVITE is used as a matching characteristic
for classifying the call to an IP Group in the Classification table. Once
classified, the device uses the URI in the To header as the
destination.

[-1] Not Configured (default)

[0] From

[1] To
359
17. Control Network
Description
Mediant 800B Gateway and E- SBC