AudioCodes Mediant 800B User Manual page 352

Parameter
Proxy Set
proxy-set-id
[IPGroup_ProxySetName]
IP Profile
ip-profile-name
[IPGroup_ProfileName]
Media Realm Name
media-realm-name
[IPGroup_MediaRealm]
SIP Group Name
sip-group-name
[IPGroup_SIPGroupName]
User's Manual
address of the IP Group in the 'GW Group Registered IP Address'
field if it is registered with the device.
Assigns a Proxy Set to the IP Group. All INVITE messages destined
to the IP Group are sent to the IP address configured for the Proxy
Set.
For configuring Proxy Sets, see ''Configuring Proxy Sets'' on page
362.
Notes:

The Proxy Set must be associated with the same SRD as that
assigned to the IP Group.

You can assign the same Proxy Set to multiple IP Groups.

For the SBC application: Proxy Sets are used for Server-type IP
Groups, but may in certain scenarios also be used for User-type
IP Groups. For example, this is required in deployments where
the device mediates between an IP PBX and a SIP Trunk, and
the SIP Trunk requires SIP registration for each user that requires
service. In such a scenario, the device must register all the users
to the SIP Trunk on behalf of the IP PBX. This is done by using
the User Info table where each user is associated with the source
IP Group (i.e., the IP PBX). For configuring the User Info table,
see SBC User Information for SBC User Database on page 761.

For the Gateway application: Proxy Sets are applicable only to
Sever-type IP Groups.
Assigns an IP Profile to the IP Group.
By default, no value is defined (None).
For configuring IP Profiles, see ''Configuring IP Profiles'' on page
396.
Assigns a Media Realm to the IP Group. The Media Realm
determines the UDP port range and maximum sessions on a specific
interface for media traffic associated with the IP Group.
By default, no value is defined (None).
For configuring Media Realms, see Configuring Media Realms on
page 323.
Notes:

For the parameter to take effect, a device reset is required.

If you delete a Media Realm from the Media Realm table that is
assigned to the IP Group, the parameter value reverts to None.
Defines the SIP Request-URI host name in INVITE and REGISTER
messages sent to this IP Group, or the host name in the From
header of INVITE messages received from this IP Group. In other
words, it replaces the original host name. .
The valid value is a string of up to 100 characters. By default, no
value is defined.
Notes:

If the parameter is not configured, the value of the global
parameter, ProxyName is used instead (see ''Configuring Proxy
and Registration Parameters'' on page 375).

The parameter overrides inbound message manipulation rules
that manipulate the host name in Request-URI, To, and/or From
SIP headers. If you configure the parameter and you want to
352
Mediant 800B Gateway and E- SBC
Description
Document #: LTRT-10296