AudioCodes Mediant 800B User Manual page 131

Media gateway & enterprise session border controller (e-sbc)

Hide thumbs Also See for Mediant 800B:

Table of Contents

User's Manual

[EtherGroupTable_Mode]

[EtherGroupTable_Member1]

[EtherGroupTable_Member2]

applies only to Ethernet Groups containing two ports.

[2] 1RX/1TX = (Default) At any given time, only a single port in the

Ethernet Group can transmit and receive packets. If a link exists on

both ports, then the active one is either the first to have a link up or

the lower-numbered port if both have the same link up from start.

[3] 2RX/1TX = Both ports in the Ethernet Group can receive

packets, but only one port can transmit. The transmitting port is

determined arbitrarily by the device. If the selected port fails at a

later stage, a switchover to the redundant port is done, which

begins to transmit as well as receive.

[4] 2RX/2TX = Both ports in the Ethernet Group can receive and

transmit packets. This option is applicable only to the Maintenance

interface for High Availability (HA) deployments. For more

information, see Network Topology Types and Rx/Tx Ethernet Port

Group Settings on page 715.

[5] Single = If the Ethernet Group contains only one port, use this

[6] None = If no port is assigned to the Ethernet Group, use this

It is recommended to use the 2RX/1TX option. In such a setup, the

ports can be connected to the same LAN switch or each to a

different switch where both are in the same subnet.

For Ethernet Group settings for the Maintenance interface when

implementing High Availability, see Initial HA Configuration on

Assigns the first port to the Ethernet Group. To assign no port, set this

field to None.

Note: Before you can re-assign a port to a different Ethernet Group,

you must first remove the port from its current Ethernet Group. To

remove the port, either set this field to None or to a different port.

Assigns the second port to the Ethernet Group. To assign no port, set

this field to None.

Note: Before you can re-assign a port to a different Ethernet Group,

you must first remove the port from its current Ethernet Group. To

remove the port, either set this field to None or to a different port.

Mediant 800B Gateway and E- SBC