Delta MS300 Series User Manual page 322

CALL NOW 800-985-6929
CALL NOW 800-985-6929
http://www.deltaacdrives.com
Content Register
2211H
2212H The multi-step speed that is executing (S)
2213H
2214H
2215H
2216H Pulse input frequency (PG2 of PG card) (XXX.XX Hz)
2217H
2218H Position command tracing error
2219H Display times of counter overload (XXX.XX %)
221AH GFF (XXX.XX %)
221BH DCbus voltage ripples (XXX.X V)
221CH PLC register D1043 data (C)
221DH Pole of Permanent Magnet Motor
221EH User page displays the value in physical measure
221FH Output Value of Pr. 00-05 (XXX.XX Hz)
2220H
2221H
2222H Fan speed of the drive (XXX %)
2223H Control mode of the drive 0: speed mode 1: torque mode
2224H Carrier frequency of the drive (XX KHZ)
2225H Reserved
2226H
2227H
2228H Torque command (XXX.X %)
2229H KWH display (XXXX.X)
222AH MI7pulse input in Low Word
222BH MI7 pulse input in High Word
222CH Motor actual position in Low Word
222DH Motor actual position in High Word
222EH PID reference (XXX.XX %)
222FH PID offset (XXX.XX %)
2230H PID output frequency (XXX.XX Hz)
2231H Hardware ID
2232H Display auxiliary frequency
2233H Display master frequency
2234H
http://www.deltaacdrives.com
Chapter 12 Description of Parameter SettingsMS300
The status of digital output (ON / OFF), refer to Pr. 02-18
(as Pr. 00-04 NOTE 4)
The corresponding CPU pin status of digital input (d.)
(as Pr. 00-04 NOTE 3)
The corresponding CPU pin status of digital output (O.)
(as Pr. 00-04 NOTE 4)
Number of actual motor revolution (PG1 of PG card) (P.) it will
start from 9 when the actual operation direction is changed or
keypad display at stop is 0. Max. is 65535
Pulse input position (PG card PG2), maximum setting is
65535.
Number of motor turns when drive operates (keeping when
drive stops, and reset to zero when operation)
Operation position of motor (keeping when drive stops, and
reset to zero when operation)
Drive status
bit 1~0 00b: No direction
01b: Forward
10b: Reverse
bit 3~2 01b: Driver ready
10b: Error
bit 4 0b: Motor drive did not output
1b: Motor drive did output
bit 5 0b: No alarm
1b: Have Alarm
Drive's estimated output torque (positive or negative direction)
(XXXX Nt-m)
Display frequency after addition and subtraction of auxiliary
and master frequency
12.1-09-10
Email: info@deltaacdrives.com
Function
Email: info@deltaacdrives.com