Delta MS300 Series User Manual page 165

CALL NOW 800-985-6929
Chapter 11 Summary of Parameter SettingsMS300
Pr.
06-23 Fault output option 1

06-24 Fault output option 2

06-25 Fault output option 3

06-26 Fault output option 4

Electronic thermal relay selection 2
06-27

(motor 2)
Electronic thermal relay action time
06-28

2 (motor 2)
06-29 PTC detection selection

06-30 PTC level

CALL NOW 800-985-6929
http://www.deltaacdrives.com
Explanation
http://www.deltaacdrives.com
Settings
87: Drive over load in low frequency (oL3)
89: Initial rotor position detection error (roPd)
101: CANopen software disconnect 1 (CGdE)
102: CANopen software disconnect 2 (CHbE)
104: CANopen hardware disconnect (CbFE)
index setting error
105: CANopen
station number setting error
106: CANopen
(CAdE)
memory error
107: CANopen
121: Internal communication error (CP20)
123: Internal communication error (CP22)
124: Internal communication error (CP30)
126: Internal communication error (CP32)
127: Software version error (CP33)
128: Over-torque 3 (ot3)
129: Over-torque 4 (ot4)
134: Electronics thermal relay 3 protection (EoL3)
135: Electronics thermal relay 4 protection (EoL4)
140: GFF detected when power on (Hd6)
141: GFF occurs before run (b4GFF)
142: Auto tuning error 1 (DC test stage) (AUE1)
143: Auto tuning error 2 (High frequency test stage)
(AUE2)
(Rotary test stage)
144: Auto tuning error 3
(AUE3)
0~65535 (refer to bit table for fault code)
0~65535 (refer to bit table for fault code)
0~65535 (refer to bit table for fault code)
0~65535 (refer to bit table for fault code)
0: Inverter motor (with external forced cooling)
1: Standard motor (motor with fan on the shaft)
2: Disabled
30.0~600.0 sec.
0: Warn and keep operation
1: Warn and ramp to stop
2: Warn and coast to stop
3: No warning
0.0 ~100.0 %
11-28
Email: info@deltaacdrives.com
Factory
Setting
(CIdE)
(CFrE)
Email: info@deltaacdrives.com
0
0
0
0
2
60.0
0
50.0