Delta MS300 Series User Manual page 321

CALL NOW 800-985-6929
Chapter 12 Description of Parameter SettingsMS300
Content
CALL NOW 800-985-6929
http://www.deltaacdrives.com
Register
1: Master frequency controlled by communication
bit 8
interface
bit 9 1: Master frequency controlled by analog signal
1: Operation command controlled by
bit 10
communication interface
bit 11 1: Parameter locked
bit 12 1: Enable to copy parameters from keypad
bit 15~13 Reserved
2102H Frequency command (XXX.XX Hz)
2103H Output frequency (XXX.XX Hz)
Output current (XX.XX A). When current is higher than 655.35,
2104H it will shift decimal as (XXX.X A). The decimal can refer to High
byte of 211F.
2105H DC-BUS voltage (XXX.X V)
2106H Output voltage (XXX.X V)
2107H Current step number of multi-stage speed operation
2108H Reserved
2109H Counter value
210AH Power factor angle (XXX.X)
210BH Output torque (XXX.X %)
210CH Actual motor speed (XXXXX rpm)
210DH Number of PG feedback pulses (0~65535)
210EH Number of PG2 pulse commands (0~65535)
210FH Power output (X.XXX KWH)
2116H Multi-function display (Pr. 00-04)
Max. operation frequency (Pr. 01-00) or Max. user defined
value (Pr. 00-26)
When Pr. 00-26 is 0, this value is equal to Pr. 01-00 setting
211BH When Pr. 00-26 is not 0, and the command source is Keypad,
this value = Pr. 00-24 * Pr. 00-26 / Pr. 01-00
When Pr. 00-26 is not 0, and the command source is 485, this
value = Pr. 09-10 * Pr. 00-26 / Pr. 01-00
211FH High byte: decimal of current value (display)
Display output current (A). When current is higher than 655.35,
2200H it will shift decimal as (XXX.X A). The decimal can refer to High
byte of 211F.
2201H Display counter value (c)
2202H Actual output frequency (XXXXX Hz)
2203H DC-BUS voltage (XXX.X V)
2204H Output voltage (XXX.X V)
2205H Power angle (XXX.X)
2206H Display actual motor speed kW of U, V, W (XXXXX kW)
Display motor speed in rpm estimated by the drive or encoder
2207H
feedback (XXXXX rpm)
Display positive / negative output torque in %, estimated by the
2208H
drive (t0.0: positive torque, -0.0: negative torque) (XXX.X %)
2209H Display PG feedback (as Pr. 00-04 NOTE 1)
220AH PID feedback value after enabling PID function (XXX.XX %)
220BH Reserved
Display signal of ACI analog input terminal, 4-V20 mA / 0-10 V
220CH
corresponds to 0.00~100.00% (2.) (as Pr. 00-04 NOTE 2)
220DH Reserved
220EH IGBT temperature of drive power module (XXX.X °C)
220FH The temperature of capacitance (XXX.X °C)
The status of digital input (ON / OFF), refer to Pr. 02-12
2210H
(as Pr. 00-04 NOTE 3)
12.1-09-9
http://www.deltaacdrives.com
Email: info@deltaacdrives.com
Function
Email: info@deltaacdrives.com