Delta MS300 Series User Manual page 139

CALL NOW 800-985-6929
Chapter 11 Summary of Parameter SettingsMS300
Pr.
Display AC motor drive rated
00-01
current
00-02 Parameter reset
00-03 Start-up display selection

Content of multi-function
 00-04
display (user defined)
CALL NOW 800-985-6929
http://www.deltaacdrives.com
Explanation
Display by models
0: No function
1: Parameter write protect
5: Reset KWH display to 0
6: Reset PLC
7: Reset CANopen index (Slave)
8: Keypad doesn't respond
9: All parameters are reset to factory settings
10: All parameters are reset to factory settings
11: All parameters are reset to factory settings
12: All parameters are reset to factory settings
0: F (frequency command)
1: H (output frequency)
2: U (multi-function display, see Pr. 00-04)
3: A (output current)
0: Display output current (A) (Unit: Amps)
1: Display counter value (c) (Unit: CNT)
2: Display actual output frequency (H.) (Unit: Hz)
3: Display DC-BUS voltage (v) (Unit: Vdc)
4: Display output voltage (E) (Unit: Vac)
5: Display output power angle (n) (Unit: deg)
6: Display output power in kW (P) (Unit: Kw)
7: Display actual motor speed rpm (Unit: rpm)
10: Display PID feedback (b) (Unit: %)
11: Display signal value of AVI analog input terminal (1.)
12: Display signal value of ACI analog input terminal (2.)
14: Display the temperature of IGBT (i.) (Unit:
16: The status of digital input (ON / OFF) (i)
17: Display digital output status ON / OFF (o)
18: Display the multi-stage speed that is executing (S)
19: The corresponding CPU pin status of digital input (d)
http://www.deltaacdrives.com
Settings
(base frequency is 50 Hz)
(base frequency is 60 Hz)
(base frequency is 50 Hz) (saving the setting value of
user defined parameter 13-01~13-50)
(base frequency is 60 Hz) (saving the setting value of
user defined parameter 13-01~13-50)
(Unit: %)
(Unit: %)
11-2
Email: info@deltaacdrives.com
Factory
Setting
Read
only
0
0
3
o
C)
Email: info@deltaacdrives.com