Digital Input / Output Parameters - Delta MS300 Series User Manual

CALL NOW 800-985-6929
Chapter 11 Summary of Parameter SettingsMS300

02 Digital Input / Output Parameters

Pr.
02-00 2-wire / 3-wire operation control
Multi-function input command 1
02-01
(MI1)
Multi-function input command 2
02-02
(MI2)
Multi-function input command 3
02-03
(MI3)
Multi-function input command 4
02-04
(MI4)
Multi-function input command 5
02-05
(MI5)
Multi-function input command 6
02-06
(MI6)
Multi-function input command 7
02-07
(MI7)
CALL NOW 800-985-6929
http://www.deltaacdrives.com
Explanation
http://www.deltaacdrives.com
Settings
0: No function
1: 2-wire mode 1, power on for operation control
(M1: FWD / STOP, M2: REV / STOP)
2: 2-wire mode 2, power on for operation control
(M1: RUN / STOP, M2: REV / FWD)
3: 3-wire, power on for operation control
(M1: RUN, M2: REV / FWD, M3: STOP)
4: 2-wire mode 1，fast start up
(M1: FWD / STOP, M2: REV / STOP)
5: 2-wire mode 2，fast start up
(M1: RUN / STOP, M2: REV / FWD)
6: 3-wire，fast start up
(M1: RUN, M2: REV / FWD, M3: STOP)
IMPORTANT
In fast start up function, terminal output will
1.
keep in ready status, drive will response to the
command immediately.
When using fast start up function, the output
2.
terminal will have higher voltage potentially.
0: No function
1: Multi-stage speed command 1 / multi-stage
position command 1
2: Multi-stage speed command 2 / multi-stage
position command 2
3: Multi-stage speed command 3 / multi-stage
position command 3
4: Multi-stage speed command 4 / multi-stage
position command 4
5: Reset
6: JOG operation (By KPC-CC01 or external
control)
7: Acceleration / deceleration speed inhibit
st nd
8: The 1 , 2 acceleration / deceleration time
selection
rd th
9: The 3 , 4 acceleration / deceleration time
selection
10: EF Input (Pr. 07-20)
11: B.B input from external (Base Block)
11-12
Email: info@deltaacdrives.com
Factory
Setting
1
0
0
1
2
3
4
0
Email: info@deltaacdrives.com