Delta MS300 Series User Manual page 216

CALL NOW 800-985-6929
CALL NOW 800-985-6929
http://www.deltaacdrives.com
Chapter 12 Description of Parameter SettingsMS300
6: JOG operation (By KPC-CC01 or external control)
7: Acceleration / deceleration speed not allow
st nd
8: The 1 , 2 acceleration / deceleration time selection
rd th
9: The 3 , 4 acceleration / deceleration time selection
10: EF input (Pr. 07-20)
11: B.B input from external (Base Block)
12: Output stop
13: Cancel the setting of the auto acceleration / deceleration time
15: Rotating speed command from AVI
16: Rotating speed command from ACI
18: Forced to stop (Pr. 07-20)
19: Digital up command
20: Digital down command
21: PID function disabled
22: Clear counter
23: Input the counter value (MI6)
24: FWD JOG command
25: REV JOG command
28: Emergency stop (EF1)
29: Signal confirmation for Y-connection
30: Signal confirmation for -connection
38: Disable write EEPROM function
40: Force coast to stop
41: HAND switch
42: AUTO switch
48: Mechanical gear ratio switch
49: Drive enable
50: Master dEb input
51: Selection for PLC mode bit 0
52: Selection for PLC mode bit 1
53: Trigger CANopen quick stop
56: Local / Remote Selection
70: Auxiliary frequency is forced to 0
71: Disable PID function, PID output is forced to 0
72: Disable PID function, remain the output value before
disabled
73: PID integral gain is forced to 0, integral disabled
74: PID feedback reversed
81: Zero point position signal input of simple positioning
82: OOB loading balance detection
83: Multi-motors (IM) selection bit 0
84: Multi-motors (IM) selection bit 1
12.1-02-3
http://www.deltaacdrives.com
Email: info@deltaacdrives.com
Email: info@deltaacdrives.com