Connecting To Sa100/Sa200 - Mitsubishi Electric GOT2000 Series Connection Manual

9.5.14

Connecting to SA100/SA200

■1. Communication settings
Make the communication settings by operating the key of the temperature controller.
Item
*1
Communication speed
*1
Data bit configuration
(Data bit, Parity bit, Stop bit)
*2
Device address
(Slave address)
*3
Interval time
*1 Adjust the settings with GOT settings.
*2 Select the device address1 without overlapping with that of other units.
*3 Set the maximum time from the sending of the last character stop bit from the GOT side until the switching of the GOT side to the
receiving status (until the temperature controller becomes ready to send). Set as necessary.
*4 When the setting value is set to 0, a communication is not made.
9.5.15 Connecting to X-TIO Module
■1. Communication settings
Make the communication settings of the temperature controller.
Item
*1
Communication speed
Communication protocol
Data bit configuration
*2
Module address
Internal data bus terminating resistor
Data interval extension time
*1 Adjust the settings with GOT settings.
*2 When the setting value is set to 0, a communication is not made.
9600bps, 19200bps
[8N1]: 8bit, None, 1bit
[8N2]: 8bit, None, 2bit
[8E1]: 8bit, Even, 1bit
[8E2]: 8bit, Even, 2bit
[8O1]: 8bit, Odd, 1bit
[8O2]: 8bit, Odd, 2bit
*4
1 to 99
0 to 250 (ms)
9600bps, 19200bps, 38400bps
MODBUS
Data bit: 8bit, Parity: None
Data bit: 8bit, Parity: Even
Data bit: 8bit, Parity: Odd
Stop bit: 1bit (fixed)
1 to 99
When combining the module, turn ON the internal data bus terminating resistor at both ends of the module.
0 to 99ms
9.5 Temperature Controller Side Setting
Setting range
Setting range
9
9 - 57