Ethernet Connection - Mitsubishi Electric GOT2000 Series Connection Manual

15.3 Ethernet Connection

15.3.1 System configuration for connecting to SIMATIC S7-300/400 series
(Ethernet connection type: FETCH/WRITE)
SIMATIC
Ethernet
S7-300/400
Module
series
PLC
Ethernet
Series
*3
model
CP343-1 IT
SIMATIC CP343-1
S7-300 CP343-1 Lean
CP343-1 Advanced
SIMATIC CP443-1 IT
S7-400 CP443-1
*1 The destination connected with the twisted pair cable varies with the configuration of the applicable Ethernet network system.
Connect to the Ethernet module, hub, transceiver or other system equipment corresponding to the applicable Ethernet network
system.
Use cables, connectors, and hubs that meet the IEEE802.3 10BASE-T/100BASE-TX standards.
*2 A length between a hub and a node.
The maximum distance differs depending on the Ethernet device to be used.
The following shows the number of the connectable nodes when a repeater hub is used.
• 10BASE-T: Max. 4 nodes for a cascade connection (500m)
• 100BASE-TX: Max. 2 nodes for a cascade connection (205m)
When switching hubs are used, the cascade connection between the switching hubs has no logical limit for the number of
cascades.
For the limit, contact the switching hub manufacturer.
*3 Product manufactured by Siemens AG. For details of the product, contact Siemens AG.
*4 If the number of GOTs increases, the communication becomes highloaded, and it may affect the communication performance.
*5 GT25-W, GT2505-V does not support the option device.
Connection cable
Connection cable
*1
Cable model
• 100BASE-TX
Shielded twisted pair cable (STP) or
unshielded twisted pair cable (UTP) of
category 5 or higher
• 10BASE-T
Shielded twisted pair cable (STP) or
unshielded twisted pair cable (UTP) of
category 3 or higher
GOT
GOT
Maximum
segment
*5
Option device
*2
length
- (Built into GOT)
100m
GT25-J71E71-
100
- (Built into GOT)
100m
GT25-J71E71-
100
15.3 Ethernet Connection
Communication driver
Ethernet( ), Gateway
SIEMENS S7
Number of connectable
equipment
Model
When PLC:GOT is N:1
16 PLCs or less for 1 GOT
When PLC:GOT is 1:N
The following shows the
number of GOTs for 1 PLC
*4
32 or less (recommended
to 16 or less)
15 - 13
15