■3. Unit address settings
Set the unit address using the unit address setting switch.
■4. Interval time settings
Configure the interval time setting using the RKC communication setting tool (WinPCI).
After the communication is started, set as follows.
Instrument
CFG file
Communication 1 interval time
Communication 2 interval time
For the using method of RKC communication setting tool, refer to the following.
➠
RKC communication setting tool user's manual
9.5.5
Connecting to CB Series
■1. Communication settings
Item
*1
Device address
*2
Communication speed
Data bit configuration
Interval time
*1
When the setting value is set to 0, a communication is not made.
*2
Adjust the settings with GOT settings.
■2. Communication setting mode
Set the communication setting mode using the operation panel of the CB series main unit.
For details of the communication setting mode, refer to the following.
➠
CB series "Communication Instruction Manual"
COM
Setting item
1 to 99
2: 9600bps
3: 19200bps
0: 8/1/None
6: 8/1/Even
7: 8/1/Odd
0 to 150
Unit address setting switch
Setting range : 0 to F
Set value
0
ZCOM_rkc.cfg
0 to 250ms
Setting range
9.5 Temperature Controller Side Setting
9
9 - 51