Station Number Setting - Mitsubishi Electric GOT2000 Series Connection Manual

9.5.20

Station number setting

Set each station number so that no station number overlaps.
The station number can be set without regard to the cable connection order. There is no problem even if station numbers
are not consecutive.
■1. Direct specification
The station number setting range of the temperature controller side differs from that of the GOT side.
Specify the station No. of the temperature controller to be changed when setting devices referring the following table.
Temperature controller
H-PCP-J
H-PCP-A
H-PCP-B
Z-TIO
Z-COM
Z-DIO
Z-CT
X-TIO
CB, FB, RB, PF, AG, HA,
MA, RMC, THV, SA, SB1
B400
■2. Indirect specification
When setting the device, indirectly specify the station number of the temperature controller of which data is to be
changed using the 16-bit GOT internal data register (GD10 to GD25).
When specifying the station No. from 100 to 115 on GT Designer3, the value of GD10 to GD25 compatible to the
station No. specification will be the station No. of the temperature controller.
Specification station NO.
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
9 - 64
9.5 Temperature Controller Side Setting
Station Station
No.3 No.10
GOT
Examples of station number setting
Module address setting of
temperature controller side
0 to F
(Hexadecimal)
0 to F
(Hexadecimal)
0 to F
(Hexadecimal)
1 to 99
(Decimal)
1 to 99
(Decimal)
1 to 99
(Decimal)
Compatible device
GD10
GD11
GD12
GD13
GD14
GD15
GD16
GD17
1 to 99
For the setting other than the above, error (dedicated device is out of range) will occur.
GD18
GD19
GD20
GD21
GD22
GD23
GD24
GD25
Station Station Station
No.1 No.15 No.6
GOT side station
number setting
1 to 16 The GOT side station number setting is the module
(Decimal) address setting value +1.
17 to 32 The GOT side station number setting is the module
(Decimal) address setting value +17.
33 to 48 The GOT side station number setting is the module
(Decimal) address setting value +33.
2 to 100 The GOT side station number setting is the module
(Decimal) address setting value +1.
1 to 99 The GOT side station number setting is the same as the
(Decimal) module address setting value.
1 to 99 The GOT side station number is the module address
(Decimal) setting value +1 or +2.
Setting range
Remark