Plc Side Setting - Mitsubishi Electric GOT2000 Series Connection Manual
Graphic operation terminal
Hide thumbs
Also See for GOT2000 Series:
- Connection manual (1224 pages) ,
- User manual (654 pages) ,
- Hardware user manual (438 pages)
Table of Contents
Advertisement
10.3.4
PLC side setting
■1. Parameter setting
Set the following parameters with the software package manufactured by the Allen-Bradley.
Item
Name
IP Address
Slot
*1
For the IP address, make the same setting as that of each Ethernet module set on GT Designer3.
Do not set the same IP Address as those of GOT and controller on the Ethernet network.
For the address setting on GT Designer3, refer to the following.
➠
*2
The EtherNet/IP communication module cannot be connected to the slot [0].
Set the slot No. to [1] or later.
10.3.5
Precautions
■1. When setting IP address
Do not use "0" and "255" at the end of an IP address.
(Numbers of *.*.*.0 and *.*.*.255 are used by the system.)
The GOT may not monitor the controller correctly with the above numbers.
Consult with the administrator of the network before setting an IP address to the GOT and controller.
■2. When connecting to multiple GOTs
(1) Setting Station
When connecting two or more GOTs in the Ethernet network, set each [Station] to the GOT.
➠
10.3.3 ■4. Ethernet setting
(2) Setting IP address
Do not use the IP address "192.168.0.18" when using multiple GOTs with the GOT 1000 series mixed.
A communication error may occur on the GOT with the IP address.
■3. When connecting to the multiple network equipment (including GOT) in a segment
By increasing the network load, the transmission speed between the GOT and PLC may be reduced.
The following actions may improve the communication performance.
• Using a switching hub
• More high speed by 100BASE-TX (100Mbps)Reduction of the monitoring points on GOT
■4. Tag name of AB native tag
When using the multiple AB native tags with long names, the monitor display speed may slow down.
For details, refer to the following manual.
➠
GT Designer3 (GOT2000) Screen Design Manual
POINT
POINT
POINT
ALLEN-BRADLEY PLC
For details of ALLEN-BRADLEY PLCs, refer to the following manuals.
➠
ALLEN-BRADLEY PLC user's Manual
10.3.3 ■2. Communication detail settings
Setting details
Sets the name.
IP address of the connected module
Slots No. for installing the EtherNet/IP communication module
10.3 Ethernet Connection
*1
*2
10 - 25
10
Advertisement
Chapters
Table of Contents
