Communication Detail Settings - Mitsubishi Electric GOT2000 Series Connection Manual

11.4.2

Communication detail settings

Make the settings according to the usage environment.
■1. GE (SNP-X)
Item
Transmission Speed
*1
Data Bit
Stop Bit
Parity
Retry
Timeout Time
Host Address
Delay Time
*1 If no setting is provided for the data length for the controller, set "8 bits".
If the setting is provided for the data length for the controller, set the same set value for the data length for the GOT as that for the
PLC.
Set this item when change the transmission speed used for communication
with the connected equipment.
(Default: 19200bps)
Set this item when change the data length used for communication with the
connected equipment.
(Default: 8bits)
Specify the stop bit length for communications.
(Default: 1bit)
Specify whether or not to perform a parity check, and how it is performed
during communication.
(Default: Odd)
Set the number of retries to be performed when a communication error
occurs.
(Default: 3times)
Set the time period for a communication to time out.
(Default: 3sec)
Specify the host address (station No. of the GOT to which the PLC is
connected) in the connected network.
(Default: 00)
Set this item to adjust the transmission timing of the communication request
from the GOT. (Default: 5ms)
POINT POINT POINT
(1) Communication interface setting by the Utility
The communication interface setting can be changed on the Utility's [Communication setting]
after writing [Communication Settings] of project data.
For details on the Utility, refer to the following manual.
➠
GOT2000 Series User's Manual (Utility)
(2) Precedence in communication settings
When settings are made by GT Designer3 or the Utility, the latest setting is effective.
Description
11.4 GOT Side Settings
Range
9600bps,
19200bps,
38400bps,
57600bps,
115200bps
7bits/8bits
1bit/2bits
None
Even
Odd
0 to 5times
1 to 30sec
00 to 31
11
0 to 300ms
11 - 13