Connection Cables For The Respective Connection; 1Got Connector Specifications - Mitsubishi Electric GOT2000 Series Connection Manual

1.4

Connection Cables for the Respective Connection

To connect the GOT to a device in the respective connection type, connection cables between the GOT and a device are
necessary.
For cables needed for each connection, refer to each chapter for connection.
1.4.1 GOT connector specifications
The following shows the connector specifications on the GOT side.
Refer to the following table when preparing connection cables by the user.
■1. RS-232 interface
Use the following as the RS-232 interface and the RS-232 communication unit connector on the GOT. For the GOT
side of the connection cable, use a connector and connector cover applicable to the GOT connector.
(1) Connector specifications
GOT
GT27
GT25
GT23
GT2107-W
GT2105-QTBDS
GT2105-QMBDS
GT15-RS2-9P
GT01-RS4-M
GT2104-RTBD
GT2104-PMBDS2
GT2103-PMBDS2
*1
(2) Connector pin arrangement
GT27, GT25, GT23, GT2107-W, GT2105-QTBDS, GT2105-QMBDS,
1 - 28

1.4 Connection Cables for the Respective Connection

Hardware
Connector type
*1
version
9-pin D-sub (male)
―
inch screw fixed type
―
9-pin D-sub (male)
inch screw fixed type
―
―
9-pin terminal block
The terminal block (MC1.5/9-ST-3.5 or corresponding product) of the cable side is packed together with the GT2104-RTBD,
GT2103-PMBDS2.
GT15-RS2-9P, GT01-RS4-M
GOT main part connector
see from the front
1 5
6 9
9-pin D-sub (male)
Connector model
17LE-23090-27(D4C )
17LE-23090-27(D3CC)
*1
MC1.5/9-G-3.5BK
GT2104-RTBD, GT2103-PMBDS2
Manufacturer
DDK Ltd.
DDK Ltd.
PHOENIX CONTACT Inc
See from the back of a
GOT main part
9-pin terminal block