GRAPHTEC gl7000 User Manual page 82

CHAPTER 3 Measure and Set
(Each Amplifier Module)
3-16
Channel settings
ALL
Input settings (Each CH)
Trigger
Alarm level settings
Voltage Output module settings
Input
Range
Filter
Span
Upper limit/Lower limit
Apply
Input
Range
Filter
Slope
Scaling settings
Scaling
Meas. Value (Upper/ Lower)
Scal. Value (Upper/ Lower)
Adjust (Meas. Value)
Adjust (Scal. Value)
Read current
Meas. Value
Scal. Value
Select (Categories)
Select (Unit selection)
Unit
Apply
Annotation
Span
Upper/Lower
Apply
Inter-CH operation settings
Inter-CH Op.
Operation
Scaling
Calculation span (Upper level)
Calculation span (Decimal point)
Calculation span (Lower level)
Select Unit(Categories)
Select Unit(Select)
Unit
Apply
Other settings
Waveform Color Setting
Color settings
Confirm
Thickness setting
Perform auto zero ADJ.
Reset auto zero ADJ.
DC Strain Module to (E)
Charge Module to (F)
Voltage Output module to (G)
Symbols References
P.3-78
P.3-100
P.3-101
P.3-102
P.3-103
to Trigger/Alarm settings
to (C)