GRAPHTEC gl7000 User Manual page 177

(13)-2 Mode
Determines the alarm mode for each channel. For details, refer to "(12)-3 Mode" on page 3-107.
(13)-3 Level/Upper limit value/Lower limit value
Sets the levels that determine the alarm.
If the mode is "High" or "Low", its set to a 1 place comparison level. If the mode is "Win in" or "Win out", its
set to a 2 place comparison level.
For details, refer to "(12)-4 Level/Upper limit value/Lower limit value" on page 3-108.
(13)-4 Output
Specifies the output destination when an alarm occurs. If multiple CH are set to the same number, it's
determined according to preset combinations.
<Ex.>: If the CH1 and CH2 of the amplifier are both set to the number 1 terminal, and the combination is
level AND, if an alarm is established on both CH1 and CH2, output will occur on the number 1 alarm
output terminal.
CHAPTER 3 Measure and Set
3-111