GRAPHTEC GL7000 User Manual

GL7-HSV
GL7000
High Speed Voltage Module
USER'S MANUAL
Thank you very much for buying this GRAPHTEC product.
This item is a standalone measuring module. Please use it by
installing it on the main module.
These directions describe preparations and cautions before
measurement.
For safe use, please make sure to read "4 Regarding
Maximum Input Voltage"
For the details concerning operation procedures etc., read
the User's manual recorded on the CD-ROM (included with
the main module)
Confirmation of the exterior
After opening the package, please confirm that there are no
problems (scratches and dirt) on the exterior before use.
Confirmation of the attached items.
User's manual (this book): 1
If by any chance faults are found, please contact the store where you
bought the item.
* Please note that items mentioned in this book may change without
prior notice.
Explanation of the module's part names and functions.
2, Module fixation screw (Upper part)
1, Module connector
4, Module fixation screw (Lower part)
1, Module connector.............. Connector for connecting all kinds of modules.
2, Module fixation screw.......
Fixation screw for the adjoining module.
(Upper part)
To prevent drop off, do not remove from
the module.
3, Power LED..........................
The Power LED will light up green when
the power has been turned on and the
module has been recognized.
4, Module fixation screw.......
Fixation screw for the adjoining module.
(Lower part)
5, Analog signal input terminal..
Terminal for inputting analog measurements.
GL7-HSV-UM-151
3, Power LED
5, Analog signal input terminal
2 How to Install Module
This explains how to attach the module to the main module.
When installing or removing the module, please
make sure that the power is off.
1, Remove the fixation screws (4 places on the upper part and
lower parts), place the alarm module parallel to the main
module and slide it in the direction of the arrow.
3 3
4 4
1 1
2 2
Alarm module Alarm module
2, Remove the high speed voltage module's fixation screws
(2 places on the lower part).
1 1
2 2
3, Slide the high speed voltage module parallel to the main
module and connect the connector.
Connector
Nail
4, Fix the high speed voltage module and the main module in
place with the screws. (4 places on the upper and lower parts)
1 1
2 2
3 3
4 4
5, Similarly, install the alarm module on the last part and fix it with
screws.
1 1
2 2
3 3
4 4
(1) Remove the fixation screws from
the 2 places on the lower part.
(2) Loosen the drop-off prevention
screws on the upper part in 2
places.
(3) Removing the alarm module.
Slide it in the direction of the
arrow. If you pry it at an angle
there is a risk of damaging the
connector.
Slide it in the direction of the
arrow.
Inserting it at an angle may cause
damage to the nails.
During installation, a
Das empfohlene Schrauben-
4kgf.cm screw tightening
Anzugsdrehmoment beträgt:
torque is recommended.
0,39 Nm.