GRAPHTEC gl7000 User Manual page 149

<DC Strain Module (GL7-DCB)>
(11)-1 Input
(11)-2 Range
(11)-3 Filter
(11)-4 Scaling
(11)-5 Annotatio
Item select
Input
Strain Bridge type
gauge * Number of wires
1
Gauge
resistor
Polarity inverse
Strain Number of wires
sensor * Bridge resistor
2
TEDS
settings *
3
Polarity inverse
Voltage
Resistance
Strain gauge Strain unit
/Strain sensor
Voltage
Resistance *
4
L.P.F
Scaling
Meas. Upper limit value
Value Lower limit value
Output Upper limit value
Lower limit value
Value
Decimal point
Unit Sorting
selection
Unit selection
Unit
(11)-1
(11)-2
(11)-3
(11)-4
(11)-5
(11)-6
(11)-7
(11)-8
Off, Strain gauge, Strain sensor, Voltage,
Resistance
Quarter bridge, Half bridge, Full bridge
2 wires, 3 wires, 4 wires, 5 wires, 6 wires
Quarter, Half bridge 120Ω, 350Ω
Full bridge Enter the number.
On, Off
4 wires, 6 wires
Enter the number.
Read TEDS Read
information
Release TEDS Release
information
Save TEDS File Enter the characters.
information name
Naming Automatic, Optional, Serial number
Save Execute
Read TEDS File Select the file.
information name
Read Execute
On, Off
–
–
με 400, 500, 800, 1000, 2000, 4000, 5000, 8000,
10000, 20000 με (με: 10
* The range depends on the bridge voltage.
mV/V 0.2, 0.25, 0.4, 0.5, 1, 2, 2.5, 4, 5, 10 mV/V
1, 2, 5, 10, 20, 50, 100, 200, 500 mV, 1, 2, 5 V
1, 2, 5, 10, 20, 50, 100, 200, 500 Ω,
1, 2, 5, 10, 20, 50 kΩ
Off, Line (1.5Hz) 3, 6, 10, 30, 50, 60, 100. 300,
500Hz, 1, 3, 5, 10kHz, Automatic (A.A.F)
Off, On
Enter the number.
Enter the number.
Enter the number.
Enter the number.
Select the decimal point value according to the
range.
Current, length, area, volume, velocity,
acceleration, frequency, weight, job, pressure,
flow rate, temperature, strain
(Selected items vary depend on the group above.)
Enter the characters.
Enter the characters. (Max. 31 characters)
CHAPTER 3 Measure and Set
Examples of selection
Strain)
–6
3-83