Table of Contents
Advertisement
If you selected SSH, click Yes.
•
Enter the user name (default = admin).
•
Enter the password (default = admin).
If you selected Telnet:
•
Enter the user name (default = admin).
•
Enter the password (default = admin).
All the commands you see in SSH are the same as the CLI commands you see through the RS-232 console.
Command Line Interface Introduction
The Command Line Interface (CLI) is the user interface to the ES7506 embedded software. You can view the
system information, show the status, configure the switch, and receive a response back from the system by
keying in a command.
There are several different command modes. Each command mode has its own access ability, available
command lines and uses different command lines to enter and exit. These modes are:
•
User EXEC Mode
on Page 100, which includes commands to ping or telnet to a remote device, and show
some basic information and to access Privileged EXEC mode
•
Privileged EXEC Mode
switch, show system information, save configuration, and access Global Configuration mode
•
Global Configuration Mode
one of the Interface Configuration modes
•
(Port) Interface Configuration
•
(VLAN) Interface Configuration
VLAN
Refer to
Configuration Using the Command Line Interface (CLI)
RocketLinx ES7506 User Guide: 2000529 Rev. F
on Page 102, which provides a view current configuration, reset default, reload
on Page 103, which you can use configure all ES7506 features and access to
on Page 104, which can be used to configure port settings
on Page 105, which can be used to configure the settings for a specific
Configuration Using the Command Line Interface (CLI)
on Page 95 to access the CLI.
Command Line Interface Introduction - 99
Advertisement
Table of Contents
