Configuring Multicast Source Port Filtering - HP A6600 Configuration Manual

Configuring a multicast group filter globally
To do...
1. Enter system view.
2. Enter IGMP-snooping view.
3. Configure a multicast group
filter.
Configuring a multicast group filter on a port or a group of ports
To do...
1. Enter system view.
2. Enter Ethernet interface/Layer
2 aggregate interface view or
port group view.
3. Configure a multicast group
filter.

Configuring multicast source port filtering

With the multicast source port filtering feature enabled on a port, the port can be connected with multicast
receivers only rather than with multicast sources, because the port will block all multicast data packets but
it permits multicast protocol packets to pass.
If this feature is disabled on a port, the port can be connected with both multicast sources and multicast
receivers.
Configuring multicast source port filtering globally
To do...
1. Enter system view.
2. Enter IGMP-snooping view.
3. Enable multicast source port
filtering.
Configuring multicast source port filtering on a port or a group of ports
To do...
1. Enter system view.
Use the command...
system-view
igmp-snooping
group-policy acl-number [ vlan
vlan-list ]
Use the command...
system-view
interface interface-type
interface-number
port-group manual
port-group-name
igmp-snooping group-policy
acl-number [ vlan vlan-list ]
Use the command...
system-view
igmp-snooping
source-deny port interface-list
Use the command...
system-view
27
Remarks
—
—
Required.
By default, no group filter is
globally configured. That is, hosts
in VLANs can join any valid
multicast group.
Remarks
—
Required.
Use either approach.
Required.
By default, no group filter is
configured on the current port.
That is, hosts on this port can join
any valid multicast group.
Remarks
—
—
Required.
Disabled by default
Remarks
—