Configuring Ipv6 Mbgp Community - HP A6600 Configuration Manual

To do...
5. Add a peer to the peer group.
6. Enter IPv6 MBGP address
family view.
7. Enable the configured IPv6
unicast BGP peer group to
create the IPv6 MBGP peer
group.
8. Add the IPv6 MBGP peer into
the peer group.
To create an IPv6 MBGP peer group, you need to enable an existing IPv6 unicast peer group in IPv6
MBGP address family view.
Before adding an IPv6 MBGP peer to the IPv6 MBGP peer group, you need to add the corresponding
IPv6 BGP unicast peer to the corresponding IPv6 BGP unicast peer group.

Configuring IPv6 MBGP community

A peer group enables a group of peers to share the same policy, and a community enables a group of
IPv6 MBGP routers in multiple ASs to share the same policy. The community attribute is propagated
among IPv6 MBGP peers and not restricted to AS boundaries.
You can reference a routing policy to modify the community attribute for routes sent to a peer. In addition,
you can define extended community attributes as needed.
To do...
1. Enter system view.
2. Enter BGP view.
3. Enter IPv6 MBGP address
family view.
4. Advertise the community
attribute to an IPv6 MBGP
peer/peer group.
5. Advertise the extended
community attribute to an IPv6
MBGP peer/peer group.
6. Apply a routing policy to
routes sent to an IPv6 MBGP
peer/peer group.
Configure a routing policy to define the community attribute, and apply the policy to outgoing routes.
For more information about routing policy configuration, see Layer 3—IP Routing Configuration Guide.
Use the command...
peer ipv6-address group
ipv6-group-name [ as-number
as-number ]
ipv6-family multicast
peer ipv6-group-name enable
peer ipv6-address group
ipv6-group-name
Use the command...
system-view
bgp as-number
ipv6-family multicast
peer { ipv6-group-name |
ipv6-address }
advertise-community
peer { ipv6-group-name |
ipv6-address }
advertise-ext-community
peer { ipv6-group-name |
ipv6-address } route-policy
route-policy-name export
380
Remarks
Required.
By default, no peer is added.
—
Required
Required
By default, no peer is added.
Remarks
—
—
—
Required.
By default, no community attribute
is advertised to any peer
group/peer.
Required.
By default, no extended
community attribute is advertised
to any peer/peer group.
Required.
Not configured by default.