Mld Proxying Configuration Example - HP A6600 Configuration Manual

UpTime: 00:13:25
Upstream interface: GigabitEthernet1/0/2
Upstream neighbor: 3002::1
RPF prime neighbor: 3002::1
Downstream interface(s) information:
Total number of downstreams: 1
1: GigabitEthernet1/0/1

MLD proxying configuration example

Network requirements
As shown in
stub network receive VOD information sent to multicast group FF3E::101.
Configure the MLD proxying feature on Router B so that Router B can maintain group memberships and
forward IPv6 multicast traffic without running IPv6 PIM-DM.
Figure 84 Network diagram for MLD proxying configuration
Procedure
Enable IPv6 forwarding and configure the IPv6 addresses
1.
Enable IPv6 forwarding on each router and configure the IPv6 address and prefix length of each interface
as per Figure
Enable IPv6 multicast routing, IPv6 PIM-DM, MLD, and MLD proxying respectively.
2.
# Enable IPv6 multicast routing on Router A, IPv6 PIM-DM on Serial 2/1, and MLD on GigabitEthernet
1/0/1.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface serial 2/0/1
[RouterA-Serial2/0/1] pim ipv6 dm
[RouterA-Serial2/0/1] quit
[RouterA] interface GigabitEthernet 1/0/1
[RouterA-GigabitEthernet1/0/1] mld enable
[RouterA-GigabitEthernet1/0/1] pim ipv6 dm
[RouterA-GigabitEthernet1/0/1] quit
Protocol: mld, UpTime: 00:13:25, Expires: -
Figure 84, IPv6 PIM-DM is required to run on the core network. Host A and Host C in the
84. The detailed configuration steps are omitted here.
294