Enabling Ipv6 Bidir-Pim; Configuring An Rp - HP A6600 Configuration Manual

Enabling IPv6 BIDIR-PIM

Perform this configuration on all routers in the IPv6 BIDIR-PIM domain.
To do...
1. Enter system view.
2. Enter IPv6 PIM view.
3. Enable IPv6 BIDIR-PIM.

Configuring an RP

An RP can be manually configured or dynamically elected through the BSR mechanism. For a large IPv6
PIM network, static RP configuration is a tedious job. Generally, static RP configuration is just a backup
means for the dynamic RP election mechanism to enhance the robustness and operation manageability of
a multicast network.
Configuring a static RP
If only one dynamic RP exists in a network, manually configuring a static RP can avoid communication
interruption due to single-point failures and avoid frequent message exchange between C-RPs and the
BSR.
Perform this configuration on all routers in the IPv6 BIDIR-PIM domain. You must perform static RP
configuration on all routers in the IPv6 PIM-SM domain and specify the same RP address.
To do...
1. Enter system view.
2. Enter IPv6 PIM view.
3. Configure a static RP for IPv6
BIDIR-PIM.
In IPv6 BIDIR-PIM, a static RP can be specified with a virtual IPv6 address. For example, if the IPv6
addresses of the interfaces at the two ends of a link are 1001::1/64 and 1001::2/64, you can specify a
virtual IPv6 address, like 1001::100/64, for the static RP. As a result, the link becomes an RPL.
Configuring a C-RP
In an IPv6 BIDIR-PIM domain, you can configure routers that intend to become the RP as C-RPs. The BSR
collects the C-RP information by receiving the C-RP-Adv messages from C-RPs or auto-RP announcements
from other routers and organizes the information into an RP-set, which is flooded throughout the entire
network. Then, the other routers in the network calculate the mappings between specific group ranges
and the corresponding RPs based on the RP-set. HP recommends that you configure C-RPs on backbone
routers.
To guard against C-RP spoofing, configure a legal C-RP address range and the range of multicast groups
to be served on the BSR. In addition, because every C-BSR has a chance to become the BSR, you must
configure the same filtering policy on all C-BSRs in the IPv6 BIDIR-PIM domain.
To do...
1. Enter system view.
Use the command...
system-view
pim ipv6
bidir-pim enable
Use the command...
system-view
pim ipv6
static-rp ipv6-rp-address
[ acl6-number ] [ preferred ] bidir
Use the command...
system-view
325
Remarks
—
—
Required.
Disabled by default.
Remarks
—
—
Required.
No static RP by default.
Remarks
—