HP A6600 Configuration Manual page 94

The hosts in N1 can join only multicast group 224.1.1.1, and the hosts in N2 can join any multicast
•
groups.
Network diagram
Figure 29 Network diagram for basic IGMP functions configuration
Procedure
Configure IP addresses and unicast routing
1.
Configure the IP address and subnet mask of each interface as per
steps are omitted here.
Configure the OSPF protocol for interoperation on the PIM network. Ensure the network-layer
interoperation on the PIM network and dynamic update of routing information among the routers through
a unicast routing protocol. The detailed configuration steps are omitted here.
Enable IP multicast routing, and enable PIM-DM and IGMP
2.
# Enable IP multicast routing on Router A, enable PIM-DM on each interface, and enable IGMP on
GigabitEthernet 1/0/1.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface GigabitEthernet 1/0/1
[RouterA-GigabitEthernet1/0/1] igmp enable
[RouterA-GigabitEthernet1/0/1] pim dm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface GigabitEthernet 0/0/0
[RouterA-GigabitEthernet0/0/0] pim dm
[RouterA-GigabitEthernet0/0/0] quit
# Enable IP multicast routing on Router B, enable PIM-DM on each interface, and enable IGMP on
GigabitEthernet 1/0/1.
<RouterB> system-view
Figure
83
29. The detailed configuration