HP A6600 Configuration Manual page 354

Figure 99 Network diagram for IPv6 PIM-SM non-scoped zone configuration
Device
Router A
Router B
Router C
Network requirements
Enable IPv6 forwarding and configure IPv6 addresses and IPv6 unicast routing
1.
Enable IPv6 forwarding on each router and configure the IPv6 address and prefix length for each
interface as per
Configure OSPFv3 on the routers in the IPv6 PIM-DM domain to ensure network-layer reachability among
them. Detailed configuration steps are omitted here.
Enable IPv6 multicast routing, and enable IPv6 PIM-SM and MLD
2.
# Enable IPv6 multicast routing on Router A, enable IPv6 PIM-SM on each interface, and enable MLD on
GigabitEthernet 1/0/1, which connects Router A to N1.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface GigabitEthernet 1/0/1
[RouterA-GigabitEthernet1/0/1] mld enable
Interface IPv6 address
GE1/0/1 1001::1/64
S2/0/0 1002::1/64
POS5/0/0 1003::1/64
GE1/0/1 2001::1/64
POS5/0/0 2002::1/64
GE1/0/1 2001::2/64
POS5/0/0 3001::1/64
Figure 99. Detailed configuration steps are omitted here.
Device Interface
Router D GE1/0/1
S2/0/0
POS5/0/0
Router E POS5/0/0
POS5/0/1
POS5/0/2
POS5/0/3
343
IPv6 address
4001::1/64
1002::2/64
4002::1/64
3001::2/64
2002::2/64
1003::2/64
4002::2/64