To do...
Enter interface view.
2.
3.
Configure MLD fast leave
processing.
Enabling the MLD host tracking function
With the MLD host tracking function, the switch can record the information of the member hosts that are
receiving IPv6 multicast traffic, including the host IPv6 address, running duration, and timeout time. You
can monitor and manage the member hosts according to the recorded information.
Enabling the MLD host tracking function globally
To do...
1.
Enter system view.
2.
Enter MLD view.
3.
Configure the MLD host
tracking function globally.
Enabling the MLD host tracking function on an interface
To do...
1.
Enter system view.
2.
Enter interface view.
3.
Enable the MLD host tracking
function on the interface.
Configuring MLD SSM mapping
Due to some possible restrictions, some receiver hosts on an SSM network might run MLDv1. To provide
SSM service support for these receiver hosts, you need to configure the MLD SSM mapping feature on the
last hop router.
Configuration prerequisites
Before you configure the MLD SSM mapping feature, complete the following tasks:
•
Enable IPv6 forwarding and configure an IPv6 unicast routing protocol so that all devices in the
domain can be interoperable at the network layer
Configure MLD basic functions
•
Use the command...
interface interface-type
interface-number
mld fast-leave [ group-policy
acl6-number ]
Use the command...
system-view
mld
host-tracking
Use the command...
system-view
interface interface-type interface-number
mld host-tracking
285
Remarks
—
Required.
Disabled by default.
Remarks
—
—
Required.
Disabled by default.
Remarks
—
—
Required.
Disabled by default.