Displaying And Maintaining Mbgp - HP A6600 Configuration Manual

To do...
6. Configure the cluster ID of the
route reflector.
In general, it is not required that clients of a route reflector be fully meshed. The route reflector forwards
routing information between clients. If clients are fully meshed, you can disable route reflection between
clients to reduce routing costs.
In general, a cluster has only one route reflector, and the router ID of the route reflector identifies the
cluster. You can configure multiple route reflectors to improve network stability. In this case, you need to
specify the same cluster ID for these route reflectors to avoid routing loops.

Displaying and maintaining MBGP

To do...
Display the IPv4 MBGP routing
table.
Display the IPv4 MBGP routing
information matching the specified
destination IP address.
Display MBGP peer group
information.
Display the advertised networks.
Display AS path information.
Display MBGP peer/peer group
information.
Display the prefix entries in the
ORF information from the
specified BGP peer.
Display MBGP routing
information.
Display MBGP routing information
matching the AS path ACL.
Display MBGP CIDR routing
information
Use the command...
reflector cluster-id cluster-id
Use the command...
display ip multicast routing-table [ verbose] [ |
{ begin | exclude | include } regular-expression ]
display ip multicast routing-table ip-address
[ mask-length | mask ] [ longer-match ] [ verbose ]
[ | { begin | exclude | include } regular-expression ]
display bgp multicast group [ group-name ] [ |
{ begin | exclude | include } regular-expression ]
display bgp multicast network [ | { begin | exclude |
include } regular-expression ]
display bgp multicast paths [ as-regular-expression |
| { begin | exclude | include } regular-expression ]
display bgp multicast peer [ [ ip-address ] verbose ]
[ | { begin | exclude | include } regular-expression ]
display bgp multicast peer ip-address received
ip-prefix [ | { begin | exclude | include }
regular-expression ]
display bgp multicast routing-table [ ip-address
[ { mask | mask-length } [ longer-prefixes ] ] ] [ |
{ begin | exclude | include } regular-expression ]
display bgp multicast routing-table as-path-acl
as-path-acl-number [ | { begin | exclude | include }
regular-expression ]
display bgp multicast routing-table cidr [ | { begin |
exclude | include } regular-expression ]
206
Remarks
Optional.
By default, a route reflector uses
its router ID as the cluster ID.
Remarks
Available in
any view.
Available in
any view.
Available in
any view.
Available in
any view.
Available in
any view.
Available in
any view.
Available in
any view.
Available in
any view.
Available in
any view.
Available in
any view.