Sa Message Filtering Configuration - HP A6600 Configuration Manual

(10.110.6.100, 225.1.1.1)
RP: 10.1.1.1 (local)
Protocol: pim-sm, Flag: SPT 2MSDP ACT
UpTime: 00:40:22
Upstream interface: Serial2/0/0
Upstream neighbor: 10.110.4.2
RPF prime neighbor: 10.110.4.2
Downstream interface(s) information:
Total number of downstreams: 1
1: GigabitEthernet1/0/1

SA message filtering configuration

Network requirements
• As shown in
among the domains to provide unicast routing.
Configure respective Loopback 0 of Router A, Router C and Router D as a C-BSR and C-RP in the
•
respective PIM-SM domain.
Set up an MSDP peering relationship between Router A and Router C and between Router C and
•
Router D.
• Source 1 sends multicast data to multicast groups 225.1.1.0/30 and 226.1.1.0/30, and Source 2
sends multicast data to multicast group 227.1.1.0/30.
Configure SA message filtering rules so that receivers Host A and Host B can receive only the
•
multicast data addressed to multicast groups 225.1.1.0/30 and 226.1.1.0/30, and Host can
receive only the multicast data addressed to multicast groups 226.1.1.0/30 and 227.1.1.0/30.
Protocol: igmp, UpTime: 00:12:07, Expires: -
Protocol: pim-sm, UpTime:
Figure 57, three PIM-SM domains exist in the network, and OSPF runs within and
- , Expires: -
188