HP A6600 Configuration Manual page 327

Configuring a static RP
If only one dynamic RP exists in a network, manually configuring a static RP can avoid communication
interruption due to single-point failures and avoid frequent message exchange between C-RPs and the
BSR.
Perform the following configuration on all the routers in the IPv6 PIM-SM domain.
To do...
1. Enter system view.
2. Enter IPv6 PIM view.
3. Configure a static RP for IPv6
PIM-SM.
To enable a static RP to work normally, you must perform this configuration on all routers in the IPv6
PIM-SM domain and specify the same RP address.
Configuring a C-RP
In an IPv6 PIM-SM domain, you can configure routers that intend to become the RP as C-RPs. The BSR
collects the C-RP information by receiving the C-RP-Adv messages from C-RPs or auto-RP announcements
from other routers and organizes the information into an RP-set, which is flooded throughout the entire
network. Then, the other routers in the network calculate the mappings between specific group ranges
and the corresponding RPs based on the RP-Set. HP recommends you to configure C-RPs on backbone
routers.
To guard against C-RP spoofing, you need to configure a legal C-RP address range and the range of IPv6
multicast groups to be served on the BSR. In addition, because every C-BSR has a chance to become the
BSR, you need to configure the same filtering policy on all C-BSRs in the IPv6 PIM-SM domain.
To do...
1. Enter system view.
2. Enter IPv6 PIM view.
3. Configure an interface to be a
C-RP for IPv6 PIM-SM.
Configure a legal C-RP
4.
address range and the range
of IPv6 multicast groups to be
served.
When configuring a C-RP, ensure a relatively large bandwidth between this C-RP and the other devices in
the IPv6 PIM-SM domain.
An RP can serve multiple IPv6 multicast groups or all IPv6 multicast groups. Only one RP can forward IPv6
multicast traffic for an IPv6 multicast group at a moment.
When configuring a C-RP, ensure a relatively large bandwidth between this C-RP and the other devices in
the IPv6 PIM-SM domain.
An RP can serve multiple IPv6 multicast groups or all IPv6 multicast groups. Only one RP can forward IPv6
multicast traffic for an IPv6 multicast group at a moment.
Use the command...
system-view
pim ipv6
static-rp ipv6-rp-address
[ acl6-number ] [ preferred ]
Use the command...
system-view
pim ipv6
c-rp ipv6-address [ { group-policy
acl6-number | scope scope-id } |
priority priority | holdtime
hold-interval |
advertisement-interval
adv-interval ] *
crp-policy acl6-number
316
Remarks
—
—
Required
No static RP by default
Remarks
—
—
Required.
No C-RPs are configured by
default.
Optional.
No restrictions by default.