Pim-Sm Admin-Scope Zone Configuration Example - HP A6600 Configuration Manual

(*, 225.1.1.0)
RP: 192.168.9.2 (local)
Protocol: pim-sm, Flag: WC
UpTime: 00:13:16
Upstream interface: Register
Upstream neighbor: 192.168.4.2
RPF prime neighbor: 192.168.4.2
Downstream interface(s) information:
Total number of downstreams: 1
1: GigabitEthernet0/0/4

PIM-SM admin-scope zone configuration example

Network requirements
As shown in
•
domain is divided into admin-scope zone 1, admin-scope zone 2, and the global scope zone.
Router B, Router C, and Router D are ZBRs of the three domains respectively.
Source 1 and Source 2 send different multicast information to multicast group 239.1.1.1. Host A
•
receives the multicast information from Source 1 only, and Host B receives the multicast information
from Source 2 only. Source 3 sends multicast information to multicast group 224.1.1.1. Host C is a
multicast receiver for this multicast group.
GigabitEthernet0/0/1 of Router B acts as a C-BSR and C-RP of admin-scope zone 1, which serve
•
the multicast group range 239.0.0.0/8. GigabitEthernet 0/0/1 of Router D acts as a C-BSR and
C-RP of admin-scope zone 2, which also serve the multicast group range 239.0.0.0/8.
GigabitEthernet 0/0/1 of Router F acts as a C-BSR and a C-RP of the global scope zone, which
serve all the multicast groups other than those in the 239.0.0.0/8 range.
IGMPv2 is required between Router A, Router E, Router I and their respective receivers.
•
Protocol: pim-sm, UpTime: 00:13:16, Expires: 00:03:22
Figure 47, receivers receive VOD information through multicast. The entire PIM-SM
145