Igmp Snooping Configuration Examples; Group Policy And Simulated Joining Configuration Example - HP A6600 Configuration Manual

IGMP snooping configuration examples

Group policy and simulated joining configuration example

Network requirements
As shown in
•
B through Ethernet 1/1.
IGMPv2 is required on Router A, IGMPv2 snooping is required on Router B. Router B is an A6600
•
router and Router A acts as the IGMP querier on the subnet.
The receivers, Host A and Host B can receive multicast traffic addressed to multicast group
•
224.1.1.1 only.
Multicast data for group 224.1.1.1 can be forwarded through GigabitEthernet 1/0/3 and
•
GigabitEthernet 1/0/4 of Router B even if Host A and Host B accidentally, temporarily stop
receiving multicast data, and that Router B drops unknown multicast data and does not broadcast
the data to the VLAN where Router B resides.
Figure 14 Network diagram for group policy simulated joining configuration
Source
1.1.1.2/24
1.1.1.1/24
Configuration procedure Procedure
Configure IP addresses
1.
Configure an IP address and subnet mask for each interface as per
steps are omitted.
Configure Router A
2.
# Enable IP multicast routing, enable PIM-DM on each interface, and enable IGMP on Ethernet 1/1.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] igmp enable
[RouterA-Ethernet1/1] pim dm
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
Figure 14, Router A connects to the multicast source through Ethernet 1/2 and to Router
Eth1/2 Eth1/1
10.1.1.1/24
Router A
IGMP querier
Receiver
Host A
GE1/0/4
GE1/0/1 GE1/0/3
Router B
GE1/0/2
Host C
32
Receiver
Host B
Figure 14. The detailed configuration