HP A6600 Configuration Manual page 69

Network diagram
Figure 23 Network diagram for creating an RPF route
Router A
GE1/0/1
50.1.1.1/24
Source 2
50.1.1.100/24
Multicast static route
Procedure
Configure IP addresses and unicast routing
1.
Configure the IP address and subnet mask for each interface as per
steps are omitted here.
Enable OSPF on Router B and Router C. Ensure the network-layer interoperation among Router B and
Router C. Ensure that the routers can dynamically update their routing information by leveraging the
unicast routing protocol. The specific configuration steps are omitted here.
Enable IP multicast routing, and enable PIM-DM and IGMP
2.
# Enable IP multicast routing on Router C, enable PIM-DM on each interface, and enable IGMP on
GigabitEthernet 1/0/1.
<RouterC> system-view
[RouterC] multicast routing-enable
[RouterC] interface GigabitEthernet 1/0/1
[RouterC-GigabitEthernet1/0/1] igmp enable
[RouterC-GigabitEthernet1/0/1] pim dm
[RouterC-GigabitEthernet1/0/1] quit
[RouterC] interface GigabitEthernet 1/0/2
[RouterC-GigabitEthernet1/0/2] pim dm
[RouterC-GigabitEthernet1/0/2] quit
# Enable IP multicast routing on Router A and enable PIM-DM on each interface.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface GigabitEthernet 1/0/1
[RouterA-GigabitEthernet1/0/1] pim dm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface GigabitEthernet 1/0/2
[RouterA-GigabitEthernet1/0/2] pim dm
[RouterA-GigabitEthernet1/0/2] quit
PIM-DM
Router B
GE1/0/2 GE1/0/3
30.1.1.2/24 30.1.1.1/24
GE1/0/1
40.1.1.1/24
OSPF domain
Router C
GE1/0/2
20.1.1.1/24
GE1/0/2
20.1.1.2/24
Source 1 Receiver
40.1.1.100/24 10.1.1.100/24
58
GE1/0/1
10.1.1.1/24
Figure 23. The detailed configuration