Mbgp Configuration Example - HP A6600 Configuration Manual

To do...
Clear MBGP route flap statistics.

MBGP configuration example

Network requirements
As shown in
PIM-SM 1 is in AS 100 and PIM-SM 2 is in AS 200. OSPF is the IGP in the two ASs, and MBGP runs
•
between the two ASs to exchange multicast route information.
• The multicast source belongs to PIM-SM 1, and the receiver belongs to PIM-SM 2.
• Configure the respective Loopback 0 of Router A and Router B as the C-BSR and C-RP of the
respective PIM-SM domains.
Set up an MSDP peer relationship between Router A and Router B through MBGP.
•
Figure 58 Network diagram for MBGP configuration
Device
Source
Router A
Router B
Use the command...
reset bgp ipv4 multicast flap-info
[ regexp as-path-regexp |
as-path-acl as-path-acl-number |
ip-address [ mask | mask-length ] ]
Figure 58:
Interface IP address
- 10.110.1.100/24
GE1/0/1 10.110.1.1/24
POS5/0/0 192.168.1.1/24
Loop0 1.1.1.1/32
POS5/0/0 192.168.1.2/24
S2/0/0 192.168.2.1/24
S2/0/1 192.168.3.1/24
Loop0 2.2.2.2/32
Remarks
Available in user view.
Device Interface
Router C GE1/0/1
S2/0/0
S2/0/1
Loop0
Router D S2/0/0
S2/0/1
Loop0
208
IP address
10.110.2.1/24
192.168.4.1/24
192.168.2.2/24
3.3.3.3/32
192.168.3.2/24
192.168.4.2/24
4.4.4.4/32