HP A6600 Configuration Manual page 168

Figure 49 Network diagram for PIM-SSM configuration
Device
Router A
Router B
Router C
Procedure
Configure IP addresses and unicast routing
1.
Configure the IP address and subnet mask for each interface as per
steps are omitted here.
Configure OSPF on the routers in the PIM-SSM domain to ensure network-layer reachability among them.
Detailed configuration steps are omitted here.
Enable IP multicast routing, and enable PIM-SM and IGMP
2.
# Enable IP multicast routing on Router A, enable PIM-SM on each interface, and run IGMPv3 on
GigabitEthernet 0/0/0, which connects Router A to the stub network.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface GigabitEthernet 0/0/0
[RouterA-GigabitEthernet0/0/0] igmp enable
Interface IP address
GE0/0/0 10.110.1.1/24
GE0/0/3 192.168.1.1/24
GE0/0/1 192.168.9.1/24
GE0/0/0 10.110.2.1/24
GE0/0/1 192.168.2.1/24
GE0/0/0 10.110.2.2/24
GE0/0/1 192.168.3.1/24
Device Interface
Router D GE0/0/0
GE0/0/3
GE0/0/1
Router E GE0/0/1
GE0/0/2
GE0/0/4
GE0/0/5
157
IP address
10.110.5.1/24
192.168.1.2/24
192.168.4.2/24
192.168.3.2/24
192.168.2.2/24
192.168.9.2/24
192.168.4.1/24
Figure 49. Detailed configuration