HP A6600 Configuration Manual page 196

Procedure
Configure IP addresses and unicast routing
1.
Configure the IP address and subnet mask for each interface as per
steps are omitted.
Configure OSPF for interconnection between the routers in the PIM-SM domain. Ensure the network-layer
interoperation among the routers, and ensure the dynamic update of routing information through a
unicast routing protocol. Detailed configuration steps are omitted.
Enable IP multicast routing, and enable PIM-SM and IGMP
2.
# Enable IP multicast routing on Router B, enable PIM-SM on each interface, and enable IGMP on the
host-side interface GigabitEthernet 1/0/1.
<RouterB> system-view
[RouterB] multicast routing-enable
[RouterB] interface GigabitEthernet 1/0/1
[RouterB-GigabitEthernet1/0/1] igmp enable
[RouterB-GigabitEthernet1/0/1] pim sm
[RouterB-GigabitEthernet1/0/1] quit
[RouterB] interface serial 2/0/0
[RouterB-Serial2/0/0] pim sm
[RouterB-Serial2/0/0] quit
[RouterB] interface pos 5/0/0
[RouterB-Pos5/0/0] pim sm
[RouterB-Pos5/0/0] quit
[RouterB] interface loopback 0
[RouterB-LoopBack0] pim sm
[RouterB-LoopBack0] quit
[RouterB] interface loopback 10
[RouterB-LoopBack10] pim sm
[RouterB-LoopBack10] quit
[RouterB] interface loopback 20
[RouterB-LoopBack20] pim sm
[RouterB-LoopBack20] quit
The configuration on Router A, Router C, Router D, and Router E is similar to the configuration on Router
B.
Configure C-BSRs and C-RPs
3.
# Configure Loopback 10 as a C-BSR and configure Loopback 20 as a C-RP on Router B.
[RouterB] pim
[RouterB-pim] c-bsr loopback 10
[RouterB-pim] c-rp loopback 20
[RouterB-pim] quit
The configuration on Router D is similar to the configuration on Router B.
Configure MSDP peers
4.
Loop10 3.3.3.3/32
Loop20 10.1.1.1/32
Router E GE1/0/1
S2/0/0
185
10.110.6.1/24
10.110.4.2/24
Figure 56. Detailed configuration